Installation Of Main Unit - Mitsubishi FX3G SERIES User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
8.4.2

Installation of main unit

The main unit must be installed before installing a special adapter or connector conversion adapter on the
enclosure.
1
Push out all DIN rail mounting hooks (A in the
right figure).
2
Fit the upper edge of the DIN rail mounting
groove (C in the right figure) onto the DIN rail.
3
Lock the DIN rail mounting hooks (D in the following figure) while pressing
the PLC against the DIN rail.
90
→ For the connection procedure, refer to Subsection 8.6.3 and Subsection 8.6.4.
D D
3 3
8.4 Procedures for Installing on and Detaching from DIN Rail
C
C
8 Installation In Enclosure
1 1
A