Mitsubishi FX3G SERIES User Manual page 199

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
When the terminal block covers are open
[9] Power supply terminal
[15] Protective terminal
covers
[9] Power supply terminal
[10] Input (X) terminals
[11] Terminal block mounting screws
[12] Terminal names
[13] Terminal block covers
[14] Output (Y) terminals
[15] Protective terminal covers
2. Side
[1] Nameplate
[2] DIN rail mounting groove
Connect the power supply to the input/output powered extension unit at this terminal.
Wire switches and sensors to these terminals.
If the input/output powered extension unit must be replaced, loosen these screws to
remove the upper part of the terminal block.
→ For anchoring the terminal block, refer to Subsection 9.1.2.
The signal names for the power supply, input terminals and output terminals are shown.
Protects the upper and lower stages of the terminal block.
Wire the intended loads (contactors, solenoid valves, etc.) to these terminals.
A protective terminal cover (refer to the following drawing) is fitted to the lower stage of
each terminal block to prevent fingers from touching terminals, thereby improving the
safety. (FX 2N - E -ES(S)/UL, UA1/UL)
[1] Nameplate
[2] DIN rail mounting groove
The product model name, control number and power supply specifications are shown.
The unit can be installed on DIN46277 rail (35mm (1.38") wide).
15 Input/Output Powered Extension Units
15.2 Power supply specifications
[10] Input (X) terminals
[11] Terminal block fitting screws
[12] Terminal names
[13] Terminal block covers
[12] Terminal names
[14] Output (Y) terminals
[11] Terminal block mounting screws
11
12
13
14
15
16
17
18
19
20
193