Mitsubishi FX3G SERIES User Manual page 286

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
2. Timer [T], counter [C]
1) Perform a monitor mode operation to display the device where the
test function is to be used. However, when not using it in a program,
a setting value is displayed as "-----". Test function cannot be used.
→ Refer to Subsection 19.6.2 for monitor function operation.
2) Press the [OK] button to display the cursor, then select the "test
subject selection screen".
To cancel the operation and return to the "monitor screen", press
[ESC].
3) Use the [+] / [-] buttons to select the test subject.
To cancel the operation and return to the "monitor screen", press
[ESC].
Test Subject
[1]
[2]
[3]
4) Hold the [OK] button for 1 second or longer to register the test
subject selection, and switch to the test mode.
To cancel the operation and return to the "test subject selection
screen", press [ESC]
Test Subject
[1]
[2]
[3]
5) Operation varies as shown below, depending on the selected test subject.
a) For "contact forced ON/OFF"
The contact ON/OFF status is highlighted when [OK] is pressed.
Button
ESC
-
+
OK
b) For "current value change","setting value change"
Use the [+] / [-] buttons to change the value as desired, then
press [OK] to register the changed value.
Button
ESC
-
+
OK
6) After the setting operation is completed, return to the "test subject selection screen", where the [ESC]
button can then be pressed to return to the "monitor screen".
280
Test Description
Contact forced ON/OFF
Current value change
Setting value change
Status when [OK] is hold for 1 second or longer
No change
Numeric value begins blinking.
Operation Description
Returns to the "test subject selection screen".
Disabled
Disabled
Highlights the contact ON/OFF status, meaning the current
value can not be changed.
Operation Description
Cancels the operation and returns to the "test subject
selection screen".
Reduces the value. Hold for 1 second or longer for high-
speed reduction.
Increases the value. Hold for 1 second or longer for high-
speed increase.
Registers the current value or the setting value and returns to
the "test subject selection screen".
19 Display Module(FX3G-5DM)
19.6 Monitor/Test Mode
[Monitor screen]
T 0 T S R
T N
T V 1 0
[Test subject selection screen]
T 0 T S R
T N
T V 1 0
[1]
T 0 T S R
T N
T V 1 0 0
T 0 T S R
T N
T V 1 0
T 0 T S R
T N
T V 1 0
T 0 T S R
T N
T V 1
0
0 0
0
0 0
[2]
0
[3]
0
0
0 0
0
0 0
0
0 0