Cellular Commands; Ph (Phone Number); S# (Iccid); Im (Imei) - Digi XBee Cellular LTE Cat 1 User Manual

AT commands
Parameter range
N/A
Default
N/A

Cellular commands

The following AT commands are cellular configuration and data commands.

PH (Phone Number)

Reads the SIM card phone number. If PH is blank, the XBee Cellular Modem is not registered to the
network.
Parameter range
N/A
Default
Set by the cellular carrier via the SIM card

S# (ICCID)

Reads the Integrated Circuit Card Identifier (ICCID) of the inserted SIM.
Parameter range
N/A
Default
Set by the SIM card

IM (IMEI)

Reads the device's International Mobile Equipment Identity (IMEI).
Parameter range
N/A
Default
Set in the factory

MN (Operator)

Reads the network operator on which the device is registered.
Parameter range
N/A
Default
Verizon
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide

Cellular commands

51