Tm (Tcp Client Connection Timeout); Do (Device Options); Eq (Device Cloud Fqdn); Addressing Commands - Digi XBee Cellular LTE Cat 1 User Manual

AT commands

TM (TCP Client Connection Timeout)

Sets or reads the TCP client connection timeout. If there is no activity for this timeout then the
connection is closed. If you set TM to 0, the connection is closed immediately after the device sends
data.
If you change the TM value while in Transparent Mode, the current connection is immediately closed.
Upon the next transmission, the TM value applies to the newly created socket.
If you change the TM value while in API Mode, the value only applies to subsequently opened sockets.
Parameter range
0 - 0xFFFF [x 100 ms]
Default
0xBB8 (5 minutes)

DO (Device Options)

Sets or displays whether Device Cloud support is enabled.
If the XBee Cellular Modem cannot establish a connection with Device Cloud, it waits 30 seconds
before trying again. On each successive connection failure, the wait time doubles (60 seconds, 120,
240, and so on) up to a maximum of 1 hour. This time resets to 30 seconds once the connection to
Device Cloud succeeds or if the device is reset.
Range
Value Description
0x00 Device Cloud support is disabled.
0x01 Device Cloud support is enabled.
Default
0x01

EQ (Device Cloud FQDN)

Sets or display the fully qualified domain name of the Device Cloud server.
Range
From 0 through 63 ASCII characters.
Default
my.devicecloud.com

Addressing commands

The following AT commands are addressing commands.

SH (Serial Number High)

The upper digits of the unique International Mobile Equipment Identity (IMEI) assigned to this device.
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide

Addressing commands

54