Connect To The Eliza Server - Digi XBee Cellular LTE Cat 1 User Manual

Getting started with the XBee Cellular Modem Development Kit
10. Click the Consoles working mode button
device. For instructions on using the Console, see
http://www.digi.com/resources/documentation/digidocs/90001458-
13/default.htm#reference/r_at_console.htm
11. Click the Open button
12. Click in the left pane of the Console log, type hello world and press Enter. The XBee Cellular
Modem sends the message to the destination phone number set by the P# command.
13. When the phone receives the text, you can see that the sender's phone number matches the
value reported by the XBee Cellular Modem with the PH command.
14. On the phone, reply with the text connect with confidence and the XBee Cellular Modem
outputs this reply from the UART.

Connect to the ELIZA server

You can use the XBee Cellular Modem to chat with the ELIZA Therapist Bot. ELIZA is an artificial
intelligence (AI) bot that emulates a therapist and can perform simple conversations.
The following table explains the AT commands that you use in this example.
At command
IP (IP Protocol)
DL (Destination
Address)
DE (Destination Port)
To communicate with the ELIZA Therapist Bot:
1. Ensure that the device is set up correctly with the SIM card installed and the antennas
connected as described in
2. Open XCTU and click the Configuration working mode
3. Select a device from the Radio Modules list. XCTU displays the current firmware settings for
that device.
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide
to open a serial connection to the device.
Value Description
1 Set the expected transmission mode to TCP
communications.
52.43.121.77 The target IP address of the Eliza server.
0x2328 The target port number of the Eliza server.
Connect the hardware.
XBee Cellular Modem examples
on the toolbar to open a serial console to the
button.
18