Td (Text Delimiter); My (Module Ip Address); La (Lookup Ip Address Of Fqdn); Od (Operating Destination Address) - Digi XBee Cellular LTE Cat 1 User Manual

AT commands
Default
0x2616

TD (Text Delimiter)

The ASCII character used as a text delimiter for Transparent mode. When you select a character,
information received over the serial port in Transparent mode is not transmitted until that character
is received. To use a carriage return, set to 0xD. Set to zero to disable text delimiter checking.
Parameter range
0 - 0xFF
Default
0x0

MY (Module IP Address)

Reads the device's IP address. This command is read-only because the IP address is assigned by the
mobile network.
In API mode, the address is represented as the binary four byte big-endian numeric value representing
the IPv4 address.
In Transparent or Command mode, the address is represented as a dotted-quad string notation.
Parameter range
0- 15 IPv4 characters
Default
0.0.0.0

LA (Lookup IP Address of FQDN)

Performs a DNS lookup of the given fully qualified domain name (FQDN) and outputs its IP address.
When you issue the command in API mode, the IP address is formatted in binary. In all other cases (for
example, Command mode) the format is dotted decimal notation.
Range
Valid FQDN.
Default
-

OD (Operating Destination Address)

Read the destination IPv4 address currently in use by Transparent mode. The value is 0.0.0.0 if no
Transparent IP connection is active.
In API mode, the address is represented as the binary four byte big-endian numeric value representing
the IPv4 address.
In Transparent or Command mode, the address is represented as a dotted-quad string notation.
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide
Addressing commands
56