Digi XBee Cellular LTE Cat 1 User Manual page 17

Getting started with the XBee Cellular Modem Development Kit
Command
AP (API Enable)
IP (IP Protocol)
P#
(Destination Phone
Number)
TD (Text Delimiter) D (0x0D)
PH (Module's SIM
phone number)
1. Ensure that the device is set up correctly with the SIM card installed and the antennas
connected as described in
2. Open XCTU and click the Configuration working mode
3. Select a device from the Radio Modules list. XCTU displays the current firmware settings for
that device.
4. On the Configuration toolbar, click the Default button
established by the firmware, and click Yes to confirm.
5. Factory settings are loaded but not written to the device. To write them, click the Write button
on the toolbar.
6. To switch to SMS communication, in the IP field, select 2 and click the Write button
7. To enter your cell phone number, in the P# field, type the <target phone number> and click
the Write button. Type the phone number using only numbers, with no dashes. You can use the
+ prefix if necessary. The target phone number is the phone number you wish to send a text to.
8. In the TD field, type D and click the Write button.
9. Note the number in the PH field; it is the XBee Cellular Modem phone number, which you see
when it sends an SMS to your phone.
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide
Value Description
0 Set the device's API mode to Transparent mode.
2 Set the expected transmission mode to SMS communication.
The target phone number that you send to, for example, your
<Target
cellular phone. See
phone
on using this command.
number>
The text delimiter to be used for Transparent mode, as an ASCII hex
code. No information is sent until this character is entered, unless
the maximum number of characters has been reached. Set to zero
to disable text delimiter checking. Set to D for a carriage return.
Read The value that represents your device's phone number as supplied
only by the SIM card. This is used to send text messages to the device
from another cellular device.
Connect the hardware.
XBee Cellular Modem examples
P# (Destination Phone Number)
button.
to load the default values
for instructions
.
17