Digi XBee Cellular LTE Cat 1 User Manual page 22

Getting started with the XBee Cellular Modem Development Kit
1. Ensure that the device is set up correctly with the SIM card installed and the antennas
connected as described in
2. Open XCTU and click the Configuration working mode
3. Select a device from the Radio Modules list. XCTU displays the current firmware settings for
that device.
4. On the Configuration toolbar, click the Default button
established by the firmware, and click Yes to confirm.
5. Factory settings are loaded but not written to the device. To write them, click the Write button
on the toolbar.
6. To switch to TCP communication, in the IP field, select 1 and click the Write button
7. To enter the destination address of the daytime server, in the DL field, type 52.43.121.77 and
click the Write button.
8. To enter the destination IP port number, in the DE field, type 232A and click the Write button.
9. To disable text delimiter checking, in the TD field, type 0 and click the Write button.
10. Click the Consoles working mode button
device. For instructions on using the Console, see
http://www.digi.com/resources/documentation/digidocs/90001458-
13/default.htm#reference/r_at_console.htm
11. Click the Open button
12. Click in the left pane of the Console log, then type in the Console to query the Daytime server.
The following screenshot provides an example of this chat.
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide
Connect the hardware.
on the toolbar to open a serial console to the
to open a serial connection to the device.
XBee Cellular Modem examples
button.
to load the default values
.
22