Cellular Commands; Ph (Phone Number); S# (Iccid); Im (Imei) - Digi XB3-C-A2-UT series User Manual

AT commands
Note Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response.
Parameter range
N/A
Default
N/A

Cellular commands

The following AT commands are cellular configuration and data commands.

PH (Phone Number)

Reads the SIM card phone number. If PH is blank, the XBee Smart Modem is not registered to the
network.
Parameter range
N/A
Default
Set by the cellular carrier via the SIM card

S# (ICCID)

Reads the Integrated Circuit Card Identifier (ICCID) of the inserted SIM.
Parameter range
N/A
Default
Set by the SIM card

IM (IMEI)

Reads the device's International Mobile Equipment Identity (IMEI).
Parameter range
N/A
Default
Set in the factory

MN (Operator)

Reads the network operator on which the device is registered.
Parameter range
N/A
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide

Cellular commands

98