Connect To The Echo Server - Digi XBee Cellular LTE Cat 1 User Manual

Getting started with the XBee Cellular Modem Development Kit
4. On the Configuration toolbar, click the Default button
established by the firmware, and click Yes to confirm.
5. Factory settings are loaded but not written to the device. To write them, click the Write button
on the toolbar.
6. To switch to TCP communication, in the IP field, select 1 and click the Write button
7. To enter the destination address of the ELIZA Therapist Bot, in the DL field, type 52.43.121.77
and click the Write button.
8. To enter the destination IP port number, in the DE field, type 2328 and click the Write button.
9. Click the Consoles working mode button
device. For instructions on using the Console, see
http://www.digi.com/resources/documentation/digidocs/90001458-
13/default.htm#reference/r_at_console.htm
10. Click the Open button
11. Click in the left pane of the Console log, then type in the Console to talk to the ELIZA Therapist
Bot. The following screenshot provides an example of this chat.

Connect to the echo server

This server echoes back the messages you type.
The following table explains the AT commands that you use in this example.
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide
on the toolbar to open a serial console to the
to open a serial connection to the device.
XBee Cellular Modem examples
to load the default values
.
19