Troubleshooting
Unresponsive cellular component in Bypass mode
When in Bypass mode, the XBee Cellular Modem does not automatically reset or reboot the cellular
component if it becomes unresponsive.
Condition
In Bypass mode, the XBee Cellular Modem does not respond to commands.
Solution
1. Query the
is connected to the XBee Cellular Modem software. If AI is 0x2F, Bypass mode should work. If
not, look at the status codes in
2. You can send the
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide
AI (Association Indication)
AI (Association Indication)
!R (Modem Reset)
command to reset only the cellular component.
Unresponsive cellular component in Bypass mode
parameter to determine whether the cellular component
for guidance.
87