I/O Sampling Commands; Tp (Temperature); Sm (Sleep Mode) - Digi XBee Cellular LTE Cat 1 User Manual

AT commands
Parameter Description
1 Fan enable. Output is low when the XBee Cellular Modem is sleeping, turning an
attached fan off when the cellular component is in a power saving mode, and also
during Airplane Mode
3 Reserved
4 Reserved
5 Reserved
Default
0

I/O sampling commands

The following AT command configures I/O sampling parameters.

TP (Temperature)

The current module temperature in degrees Celsius in 8-bit two's compliment format. For example
0x1A = 26°C, and 0xF6 = -10°C.
Parameter range
This is a read-only parameter
Default
N/A

SM (Sleep Mode)

Sets or reads the sleep mode of the device.
The sleep mode determines how the device enters and exits a power saving sleep.
Parameter range
0, 1, 4, 5
Parameter Description
0 Normal. In this mode the device never sleeps.
1 Pin Sleep. In this mode
the device honors the SLEEP_RQ pin. Set
request function: 1.
4 Cyclic Sleep. In this mode
the device repeatedly sleeps for the value specified by SP and spends ST time awake.
5 Cyclic Sleep with Pin Wake. In this mode the device acts as in Cyclic Sleep but does not
sleep if the SLEEP_RQ pin is inactive, allowing the device to be kept awake or woken by
the connected system.
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide

I/O sampling commands

D8 (DIO8/SLEEP_REQUEST) to the sleep
61