Connect To The Daytime Server - Digi XBee Cellular LTE Cat 1 User Manual

Getting started with the XBee Cellular Modem Development Kit
10. Click the Consoles working mode button
device. For instructions on using the Console, see
http://www.digi.com/resources/documentation/digidocs/90001458-
13/default.htm#reference/r_at_console.htm
11. Click the Open button
12. Click in the left pane of the Console log, then type in the Console to talk to the echo server.
The following screenshot provides an example of this chat.

Connect to the Daytime server

The Daytime server reports the current Coordinated Universal Time (UTC) value responding to any
user input.
The following table explains the AT commands that you use in this example.
At
command Value
IP (IP 1
Protocol)
DL 52.43.121.77 The target IP of the Daytime server.
(Destination
Address)
DE 0x232A
(Destination
Port)
TD (Text
0
Delimiter)
To communicate with the Daytime server:
Digi XBee Cellular LTE Cat 1 Embedded Modem User Guide
on the toolbar to open a serial console to the
to open a serial connection to the device.
Description
Set the expected transmission mode to TCP communications.
The target port number of the Daytime server.
The text delimiter to be used for Transparent mode, as an ASCII hex
code. No information is sent until this character is entered, unless the
maximum number of characters has been reached. Set to zero to
disable text delimiter checking.
XBee Cellular Modem examples
21