Removing A Storage Interface Card - IBM BladeCenter HS22V 7871 Problem Determination And Service Manual

7. Use your fingers to hold the edge of the CFFh expansion card where it
8. Pull the card away from the expansion-card standoff.

Removing a storage interface card

Use this information to remove a storage interface card from the blade server.
The storage interface card controls the SAS storage drives. The following
illustrations and installation instructions show how to remove a
ServeRAID-MR10ie CIOv storage interface card from the blade server. The
illustrations and removal instructions are similar for other CIOv storage interface
cards.
ServeRAID
controller
To remove a storage interface card, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on page
4. If an optional expansion unit is installed, remove the expansion unit (see
5. To remove the storage interface card, complete the following steps.
76
BladeCenter HS22V Type 7871 and 1949: Problem Determination and Service Guide
connects to the blade expansion connector; then, lift up on the card.
page 49.
the blade server from the BladeCenter unit" on page 52 for instructions).
55 for instructions).
"Removing an optional expansion unit" on page 57). The storage-interface-card
option includes the storage interface card, backup battery, and backup-battery
cable. These parts can be removed separately from each other.
a. Locate the storage interface card installed in the CIOv connector on the
system board (see "Blade server connectors" on page 14).
Cable "B "