IBM BladeCenter HS22V 7871 Problem Determination And Service Manual page 170

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing, Types 7871 and 1949," on page 41 to determine which components are customer
replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
Trained service technician.
Error code Description
0058009 All DIMM slots disabled. Slot 2 re-enabled,
no OS boot.
0068001 Planar POST failure.
0068002 CMOS battery cleared.
0068003 Event timer failure.
154
BladeCenter HS22V Type 7871 and 1949: Problem Determination and Service Guide
Action
1. If you disabled the DIMM, run the Setup utility
and enable the DIMM (see "Using the Setup
utility" on page 20).
2. Make sure that the DIMM is installed correctly
(see "Installing the system-board assembly" on
page 95 for more information).
3. Reseat the DIMM (see "Removing the
system-board assembly" on page 94 and
"Installing the system-board assembly" on page
95).
4. Replace the DIMM (see "Removing the
system-board assembly" on page 94 and
"Installing the system-board assembly" on page
95).
1. Restart the server.
2. (Trained service technician only) If the problem
remains, replace the system board. See
"Removing the system-board assembly" on page
94 and "Installing the system-board assembly" on
page 95.
1. Reseat the battery.
2. Clear the CMOS memory (see "System-board
switches" on page 15).
3. Replace the following components one at a time
in the order shown, restarting the server each
time:
v Battery (see "Removing the battery" on page
71"Removing the battery" on page 71 and
"Installing the battery" on page 72).
v (Trained service technician only) System board.
See "Removing the system-board assembly" on
page 94 and "Installing the system-board
assembly" on page 95.
(Trained service technician only) Replace the system
board See "Removing the system-board assembly"
on page 94 and "Installing the system-board
assembly" on page 95