Table of Contents
Advertisement
4. Touch the static-protective package that contains the DIMM to any unpainted
5. To install the DIMMs, repeat the following steps for each DIMM that you
6. If the DIMM access door is open, use your fingers to close it.
7. Install the cover onto the blade server (see "Closing the blade server cover" on
8. Install the blade server into the BladeCenter unit (see "Installing the blade
Removing a USB Flash key
Use this information to remove a USB Flash key from the blade server.
68
BladeCenter HS22 Type 7870, 1936, and 1911: Problem Determination and Service Guide
metal surface on the BladeCenter unit or any unpainted metal surface on any
other grounded rack component in the rack in which you are installing the
DIMM for at least two seconds; then, remove the DIMM from its package.
install:
DIMM
a. Make sure that the retaining clips are in the open position, away from the
center of the DIMM connector.
b. Turn the DIMM so that the DIMM keys align correctly with the DIMM
connector on the system board.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
c. Press the DIMM into the DIMM connector. The retaining clips will lock the
DIMM into the connector.
d. Make sure that the small tabs on the retaining clips are in the notches on
the DIMM. If there is a gap between the DIMM and the retaining clips, the
DIMM has not been correctly installed. Press the DIMM firmly into the
connector, and then press the retaining clips toward the DIMM until the
tabs are fully seated. When the DIMM is correctly installed, the retaining
clips are parallel to the sides of the DIMM.
page 56).
server in a BladeCenter unit" on page 53).
Retaining
clip
Advertisement
Table of Contents
