Table of Contents
Advertisement
1.
Check that paper in the paper tray is not being used, and then pull out the paper tray
carefully. Adjust the paper size dial to match the size and feed direction of the paper in
the paper tray.
2.
Pull the tray carefully until it stops, lift the front side of the tray, and then pull it out of the
machine.
Place the tray on a flat surface.
DQC256
DQC212
DQC213
Loading Paper
121
- Quick Links:
- Adding Toner
- Disposing of Used Toner
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MP 402SPF and is the answer not in the manual?
Questions and answers
how to connect to a computer
To connect a Ricoh MP 402SPF to a computer, follow these steps:
1. Network Connection (Using Ethernet)
- Insert one end of the Ethernet cable into the printer’s Ethernet port.
- Insert the other end into the computer or network router.
- Plug the power cord into a wall socket and turn on the printer.
- Wait for the printer to recognize the network connection (this may take up to a minute).
2. Driver Installation (Using a CD-ROM)
- Insert the provided CD-ROM into the computer’s CD drive.
- Open File Explorer and double-click the CD-ROM drive.
- Run "Setup.exe" to start the installation process.
- Follow the on-screen instructions to install the printer driver.
3. Network Quick Install (For Network Setup)
- Open the installer and click [Network Quick Install].
- Accept the software license agreement and click [Next].
- Select the machine model (Ricoh MP 402SPF) from the list.
- Click [Install] to complete the setup.
4. Confirm Computer Information (If Needed for Scanning or Network Setup)
- Open Command Prompt and type `ipconfig/all` to find the computer’s name and IP address.
- Type `set user` to confirm the user name.
After completing these steps, the Ricoh MP 402SPF should be connected and ready for use.
This answer is automatically generated