System Customizations; Headset Use; Headset Prior - Yealink SIP-T29G User Manual

User Guide for the SIP-T29G IP Phone

System Customizations

Headset Use

If you want to use a wired headset, physically connect your headset to the phone and activate
the headset mode for use. For more information on physically connecting a headset, refer to
Phone Installation
If you want to use a wireless headset, insert the Bluetooth
back of the IP phone. For more information on using a Bluetooth headset, refer to
86.
provides an introduction to wired headset use.
This section
Note
If both a Bluetooth headset and a wired headset are connected, only the Bluetooth headset can
be used.
To use headset, make sure the headset mode is enabled. Contact your system administrator
for more information.
Headset Mode Activation/Deactivation
To activate the headset mode:
Press
1.
The HEADSET key LED illuminates solid green and the headset icon
screen.
Press the line key or the Answer soft key to answer an incoming call. The call will be
connected to your headset automatically.
Enter the desired number and then press the Send soft key, the phone will then place a call
using the headset automatically. For more information on using the headset to place a call,
refer to Placing Calls
To deactivate the headset mode:
Press
1.
The HEADSET key LED goes out and the headset icon

Headset Prior

You can use headset in priority when headset prior feature is enabled. This feature is especially
useful for permanent or full-time headset users.
To enable headset prior via web user interface:
Click on Features->General Information.
1.
84
on page 20.
on the phone.
on page 117.
again on the phone.
USB dongle into the USB port at the
Bluetooth
appears on the idle
disappears from the idle screen.
on page