Using Intercom - Yealink SIP-T29G User Manual

User Guide for the SIP-T29G IP Phone
To configure intercom features via phone user interface:
Press Menu->Features->Intercom.
1.
Make the desired changes.
2.
Press the Save soft key to accept the change or the Back soft key to cancel.
3.
Intercom features are configurable via web user interface at the path Features->Intercom.

Using Intercom

You can use the intercom key in the following ways:
Place a call to the target extension

Pick up an incoming call of the target extension

To use the intercom key to pick up an incoming call, make sure the intercom subscription feature
Note
is enabled. For more information, contact your system administrator.
Placing an Intercom Call to the Target Extension
To place an intercom call when the target phone is idle:
Press the intercom key when the phone is idle.
1.
The target extension plays a warning tone and automatically answers the call in the
speakerphone mode by default.
To end the intercom call, press the intercom key again or the End Call soft key.
2.
Picking up an Incoming Call of the Target Extension
When the target extension receives an incoming call, the intercom key LED of the target
extension will flash green. If you configure the directed call pickup code in advance, you can pick
up the target extension's incoming call by pressing the intercom key. You can configure the
directed call pickup code when configuring an intercom key. For more information, refer to
Configuring an Intercom Key
If you enable visual alert feature, you can also pick up the target extension's incoming call by
182
on page 180.