Using Multicast Paging - Yealink SIP-T29G User Manual

User Guide for the SIP-T29G IP Phone
The default channel is 0.
Click Confirm to accept the change.
7.
The priorities of listening addresses are predefined: 1 with the highest priority, 31 with the lowest.
Note
Multicast listening addresses are configurable via web user interface only.

Using Multicast Paging

To send RTP stream via a multicast paging key when the receiver's phone is idle:
Press the multicast paging key when the phone is idle.
1.
The phone sends RTP to a preconfigured multicast address (IP: Port).
Both the sender's and receiver's phones play a warning tone and the receiver automatically
answers the multicast RTP session in the speakerphone mode.
The multicast paging key LED illuminates solid green.
The following figure shows a multicast RTP session on the phone:
188