HBM MP85A Operating Manual page 64

64
⇒
MP85A(DP)(-S)
Set outputs per data word
Specify Flash parameter set
Parameter set is loading
%
PLC MP85A(DP)(-S) control input
Sensor zero balance
Shunt calibration
Transducer test
Load parameter set
Start/end process
HBM
digital input PLC
MP85A process controller
Description
You can set the digital outputs via the SDO
object 2320 (hex), subindex 0. With this op-
tion, you can forward individual bits of the By-
tes transferred with this object to the relevant
outputs
Allows you to specify the number of a para-
meter set loaded from the Flash: The parame-
ter set number is output as a binary number
(Bit 0 to Bit 4).
Parameter sets loaded from the MMC/SD
card or PC cannot be queried
You can control the time required for loading a
parameter set with this function: The next pro-
cess can only be started after switchover
which can take up to 200 ms, the MP85A pro-
cess controller is only ready for measurement
after switchover. As long as the signal is ac-
tive therefore, no new process can be started
Description
Enables a zero balance of the sensor
Activates the shunt resistance, e.g. to gene-
rate a defined signal
Implements a transducer test
Loads a parameter set. If, for example, only
three different parameter sets are required,
you can just use two inputs for parameter set
loading, Bit 0* and Bit 1*, you do not need to
assign all bits (parameter set 0 is the default
setting).
Specify via the signal condition whether the
zero value is retained during loading or whe-
ther the zero value from the parameter set
should be used.
Specify via data storage whether the device
name is retained during loading or whether
the device name from the parameter set
should be used
Use this input to start/end a process or the
measurement. If you enter further start, stop
or end conditions in the control settings, these
will also apply
A2392−5.0 en