Overview Of All Groups And Parameters - HBM MP85A Operating Manual

42
as a backup ("S-Status Save") and reloaded into the MP85A process
controller where necessary. When loading, you can select whether loading
should take place without interface parameters ("S-Status Restore") or with
interface parameters ("S-Status Load-Com"), see Chapter 5.1.3. Confirm the
action by pressing the SET button. Progress is displayed as a % display in the
device display.
CAUTION
No measurements or evaluations are implemented during a device
backup and the response times of the device to the software or control-
lers take longer!

5.1.2 Overview of all groups and parameters

SET
+
+
CAN-BUS
Up
Baudrate
−
Address
Down
MNGRP
HBM
Groups
−
ETHERNET
MAC address
IP-Adr.1
IP-Adr.2
IP-Adr.3
IP-Adr.4
SubNetM1
(subnet mask)
SubNetM2
SubNetM3
SubNetM4
IPGatew1
IPGatew2
IPGatew3
IPGatew4
MNGRP
MP85A process controller
PROFIBUS ADD. FUNCTION
Ampl.Type
Address
(amplifier type)
PrgVers
MNGRP
(firmware version)
SrNo
(serial number)
HW vers.
(hardware version)
SD/MMCLo
MNGRP
SYSTEM-STATE
Backup Save
Backup Restore
Backup Load-Com
MNGRP
A2392−5.0 en