HBM MP85A Operating Manual page 41

MP85A process controller
NOTE
The possible error messages are summarized in Chapter 10, "Error mes-
sages".
7. Firmware update (F-Update)
To update the firmware, use the program PME Update. A description of the
procedure can be found in the online help. The program can be used to
transfer a new firmware version to several devices simultaneously. In order
not to conflict with the processing of a process (no measurements or evalu-
ations can be implemented during an update), you can specific from firmware
version 2.22 or higher that the firmware update is only implemented on the
device following manual confirmation (F-Update: Permitted!). If confirmation
does not occur within 15 minutes, no changes are made to the firmware.
The firmware update program is available on the System CD or can be down-
loaded from the HBM website.
We recommend saving the device settings (device backup) before any
updates.
8. Device backup
All MP85A process controller settings can be saved to MMC/SD card via the
integrated keyboard and then, e.g. transferred to another MP85A process
controller.
Using the device menu, all 31 Flash parameter sets, including all interface
settings of the MP85A process controller, can be saved to the memory card
A2392−5.0 en
41
Status
HBM