Ethernet Interface - HBM MP85A Operating Manual

MP85A process controller

3.6.1 Ethernet interface

An RJ45 socket for Ethernet connection is located underneath the MP85A
process controller as standard.
Fig. 3.11: Ethernet connection
The device can also be integrated into an existing Ethernet network. It
supports speeds of 10 Mbit/s and 100 Mbit/s. The transmission speed is auto-
matically adapted to the existing network. Category 5 or higher cables must
be used for this. This enables line lengths of 100 m to be implemented.
Fig. 3.12: Integrating the MP85A process controller into an existing Ethernet
network
Notes on operation in an Ethernet network
In order to avoid network problems, you should check the following points
before connection to an Ethernet network:
• Are the connected device addresses unique, i.e. no identical IP addresses?
A2392−5.0 en
RJ45
29
HBM