Pme Assistant Operation; Using The Ethernet Interface - HBM MP85A Operating Manual

48
NOTE
The minimum requirements listed above are sufficient if you are only
connecting one device. Suitable, more powerful PC hardware and more
main memory are necessary if you also wish to transfer result and curve
files from several devices to PC.
Further information can be found in the quick start guide "FASTpress
Suite".

5.4 PME Assistant operation

Interface
type
Opens the
Setup window
Fig. 5.2 Start window

5.4.1 Using the Ethernet interface

Launch the PME Assistant program and enter the required interface connec-
tion in the Start window:
• In the Interface field, select "TCP/IP". The PME Assistant now gives you
the option of using the preset IP address or setting a new one.
The address cannot be assigned automatically via DHCP. So you must
•
make sure that the IP address of the MP85A process controller differs
from the address of the network being used in max. one segment.
HBM
MP85A process controller
192 168 169 10
Factory settings
for the interface
Scanning the bus
for connected PME
modules
A2392−5.0 en