General Information - HBM MP85A Operating Manual

MP85A process controller
Accessories:
• DT85: 1/4" VGA b/w display for visualization and parameterization of
several MP85A.process controllers via the CAN interface
• Memory card: MMC or SD Card, e.g. Transcend (www.transcend.de), no
SDHC (High Capacity), SDXC (eXtended Capacity), SecureMMC or
equivalent cards
• Standard flat ribbon cable, 10-pin, 1.27 mm pitch
• Ethernet crossover cable, 2 m, (1-KAB239-2)

1.2 General information

The MP85A process controller from the PME product line is a twin-channel
amplifier, suitable for connecting transducers of different technologies. The
MP85ADP and MP85ADP-S also have a PROFIBUS interface in addition to
the ETHERNET and CAN interfaces.
Carrier-frequency bridge
excitation voltage 4.8 kHz
Power supply for active
transducers 5 V or 24 V
"10V
MP85A(DP)/MP85A(DP)-S
SSI
Fig. 1.1: Block diagram of the MP85A process controller
The PME Assistant provides a simple and free user interface for device para-
meterization under MS Windows.
This needs an Ethernet (crossover) cable (order no. 1-KAB2392) for direction
connection to a PC or a USB → CAN interface converter (when using a CAN
interface), which must be ordered separately (order number: 1-PMESETUP-
USB).
All device parameters can be set with this software. The Ethernet or CAN bus
interface is set directly at the device.
Other devices in the PME product family can also be set up with this software
(MP01 ... MP70).
A2392−5.0 en
electrically isolated
EEPROM
A
D
Intelligent signal conditioning
and powerful algorithms for
monitoring fitting
A
D
K
eyboard and
MMC/SD
display
memory card
Voltage supply,
μP
11
24 V
Control inputs and
outputs, or switch test
inputs
CANopen interface
Ethernet interface
PROFIBUS DP interface
(for MP85ADP and
MP85ADP-S)
HBM