HBM MP85A Operating Manual page 32

32
Installation:
• Connect the MP85ADP(-S) to a 24 V supply voltage and use the keyboard
or the Setup program to set the required PROFIBUS address.
• Connect the PROFIBUS line to the MP85ADP(-S). Make sure that termina-
tion resistors are connected on the first and last PROFIBUS nodes (there is
usually a slide switch on the housing of the PROFIBUS plug for this).
Example:
PROFIBUS plug
First device in
the bus cable
PROFIBUS connector slide switch set to
"
Resistor ON"
Fig. 3.16: PROFIBUS operation
HBM
MP85A process controller
PROFIBUS plug
Last device in
the bus cable
PROFIBUS connector slide
"
switch set to Resistor ON"
A2392−5.0 en