HBM MP85A Operating Manual page 39

MP85A process controller
• Output
4. PROFIBUS status (MP85ADP and MP85ADP-S only)
BD_SEAR (baudrate search)
WT_PARM (waiting for parameterization)
WT_CONF (waiting for configuration)
DATA_EX (cyclic data traffic)
ERROR (bus error)
5. Status of memory card (MMC/SD Card)
The optional memory card can be used if necessary to store measurement
curves, measurement results and even parameter sets (measurement
programs).
You can use either an SD card or a MultiMediaCard (MMC) up to 2 GB. The
PME Assistant (menu: Data storage) can be used to select what should be
saved and which medium (memory card or PC).
Up to 300,000 measurement curves can be stored on a memory card with 1
GB storage capacity. In addition, up to 31 parameter sets in XML format and
up to 1000 parameter sets in binary format can be stored.
Parameter sets in XML format can be loaded into the -device via the front
panel keyboard. Binary parameter sets can be selected using the PME
Assistant or the interface.
CAUTION
Only use standard MMC cards, not SecureMMC, MMCplus
TM
bile , SDHC (SD High Capacity), SDXC cards (SD eXtended Capacity)
or equivalent cards. The data transmission speed is not increased, but
incompatibility problems could occur. MMC or SD cards must be format-
ted with FAT16, not with NTFS, otherwise they will not be recognized by
the MP85A process controller. If necessary, reformat the card.
The MMC/SD card should be defragmented or reformatted at regular intervals
to optimize the access times.
A2392−5.0 en
set not set
39
TM
, MMCmo-
HBM