Table of Contents
Advertisement
MP85A process controller
•
In the subnet mask, a zero must be set in this position. All other
segments in the subnet mask must be set to 255.
•
Now use the "Add IP to device list" button to transfer the IP address of
the MP85A process controller to the device list.
Alternatively, you can also press the "Scan" button to run a bus scan. In
this case, all the devices found will be displayed in the device list.
If several MP85A process controllers are connected to the Ethernet
•
network via a switch, for example, make sure that each address has only
been used once. If you do not know the settings, you can query them via
the MP85A process controller keyboard (see Chapter 5.1.2).
•
Use the "Start" button to launch the PME Assistant. The MP85A process
controller automatically sets the transmission speed to 10 Mbit or 100
Mbit.
5.4.2 Using the USB interface
Launch the PME Assistant program and take the following steps to configure
the USB interface:
•
In the Interface field, select "CAN". The PME Assistant now gives you the
option of selecting the CAN network to be used.
The baudrate in the CAN network must be the same. In the delivery
•
condition, the baudrate of the MP85A process controller is set to 1 MBit/s.
•
If you select "Use as standard", this network will be chosen automatically
the next time the system starts up.
If several MP85A process controllers are connected to the CAN network,
•
make sure that each address has only been used once. If you do not
know the settings, you can query them via the MP85A process controller
keyboard (see Chapter 5.1.2).
•
Click the "Scan" button. The PME Assistant now searches for devices
connected to the CAN network and includes them in the device list.
•
Use the "Start" button to launch the PME Assistant.
A2392−5.0 en
49
HBM
Hide quick links:
Advertisement
Table of Contents
