HBM MP85A Operating Manual page 43

MP85A process controller
SET
with
MNGRP:
SD/MMCLo:
Gives you the option of loading a parameter set (XML format only) that has
previously been stored on the MMC/SD card with the PME Assistant or
INDUSTRYmonitor. Use keys
IP gateway:
From firmware version 2.20, the gateway address can be entered for cross-
segment device access in the Ethernet network.
System-state:
From firmware version 2.22, you can save the MP85A process controller
settings to an MMC/SD card or e.g. load them into another MP85A process
controller. "S-Status Restore" restores all settings, "S-Status Load-Com"
restores all settings except the addresses (CAN/Ethernet/PROFIBUS).
A2392−5.0 en
, back to main group
+
and
−
to select the required parameter set.
43
HBM