HBM MP85A Operating Manual page 40

40
Display
unused
No memory card
Init...
SET ³ STOP
Saving
Stopped
6. Kinds of error
During measurement, the ! character in the status field (in measuring mode)
indicates an MP85A process controller error.
Errors are displayed successively (can be reached using
− ERROR x (relative to the SENSOR X screw terminal)
− ERROR y (relative to the SENSOR Y screw terminal)
TIP:
The relevant device status is clearly displayed with an error overview in the
PME Assistant "Status overview" dialog. Open the dialog via the "Status"
button in the Measured value display window.
The meaning of the displays and possible corrective measures for error
messages are listed in the online help (use F1 to call the Help). Further valu-
able tips and setting assistants can be found in the FAQ section.
HBM
No data should be saved to the memory card.
Data should be saved to the memory when anything else appears
on the display.
The device has no memory card inserted.
The memory card is initialized automatically on insertion.
The memory card is ready for storage. Pressing SET changes the
status to STOP. The memory card can then be removed.
Data are being written to the memory card. Once writing is com-
plete, the status changes to "Ready"; SET ³ STOP appears on
the display.
Before removing the memory card from the device, you must
press the SET key. This will close all the files and write the
FAT.
The display briefly shows the message "MMC/SD Disk Closed" or,
in the case of error, "MMC DiskClose Err". The MMC/SD card then
switches to the "Stopped" status and can be removed from the de-
vice. If there is no more space left on the memory card, it automati-
cally switches to the "Stopped" status. This status can only be left
when the memory card is removed from the device. Re-initializa-
tion then follows automatically.
MP85A process controller
Significance
+
).
−
SENSOR X
SENSOR Y
A2392−5.0 en