The parameters are:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/
subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
•
For a port channel interface, enter the keywords port-channel then a number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
•
Match destination routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip address prefix-list-name
•
Match destination routes specified in a prefix list (IPv6).
CONFIG-ROUTE-MAP mode
match ipv6 address prefix-list-name
•
Match next-hop routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip next-hop {access-list-name | prefix-list prefix-list-name}
•
Match next-hop routes specified in a prefix list (IPv6).
CONFIG-ROUTE-MAP mode
match ipv6 next-hop {access-list-name | prefix-list prefix-list-name}
•
Match source routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip route-source {access-list-name | prefix-list prefix-list-name}
•
Match source routes specified in a prefix list (IPv6).
CONFIG-ROUTE-MAP mode
match ipv6 route-source {access-list-name | prefix-list prefix-list-name}
•
Match routes with a specific value.
CONFIG-ROUTE-MAP mode
match metric metric-value
•
Match BGP routes based on the ORIGIN attribute.
CONFIG-ROUTE-MAP mode
match origin {egp | igp | incomplete}
•
Match routes specified as internal or external to OSPF, ISIS level-1, ISIS level-2, or locally generated.
CONFIG-ROUTE-MAP mode
match route-type {external [type-1 | type-2] | internal | level-1 | level-2 |
local }
•
Match routes with a specific tag.
CONFIG-ROUTE-MAP mode
match tag tag-value
Access Control Lists (ACLs)
145