Updating Ld 800Dn Firmware - ABB AC 800M Configuration

Updating LD 800DN Firmware

The BridgeWay Configuration window is divided into the following three panes:
•
•
•
Updating LD 800DN Firmware
You can perform a Flash Update of the LD 800DN's firmware, using the BridgeWay
Configuration tool.
Follow these steps for updating the firmware of the linking device:
1.
2.
For Modular DeviceNet devices, LD establishes connection only to the adapter,
since the connection size is mismatched connection will fail and the whole device
is marked error. If the query interface is in then user can see which specific I/O
module has created this problem as the I/O module which is physically not
available will be marked as Device Not found.
176
BridgeWay Configuration - Used for displaying the module type and the
status information about the detected LD 800DN module.
Ethernet Configuration - Used for configuring the Ethernet network
parameters.
DeviceNet Configuration - Used for configuring the DeviceNet network
parameters. It also displays network interface status.
Launch the BridgeWay Configuration tool, by selecting
Start > BridgeWay Configuration. The tool connect to the LD 800DN
module and the BridgeWay Configuration user interface appears
as shown in Figure 64.
Click Update from the Flash menu in the menu bar. The Flash Update window
appears as shown in Figure 65.
Section 6 Linking Device LD 800DN
9ARD000014-600 A