ABB AC 800M Configuration page 128

Communication Related Parameters
Default
Parameter
Value
Inhibit Time 1 ms
COS Depends
Connection on the
Enabled device
support
as stated
in its
EDS file.
Conn COS Depends
InputSize on the
device
support
as stated
in its
EDS file.
Conn COS Depends
OutputSize on the
device
support
as stated
in its
EDS file.
Strobe Connection
The Strobe Connection parameters in the hardware editor are described in
Upon modification of editable parameters, the connection between LD 800DN and
all DeviceNet slaves configured under it, stops momentarily.
128
Table 20. COS Connection Parameters (Continued)
Read Only/
Type
Editable
Int Editable
Enum Editable
Int Read Only
Int Read Only
Description
This is the new data production inhibit time. This is
the rate at which the slave produces the data even
if it has a new value before this time.
Enable or disable the connection. If enabled,
linking device communicates with the device over
the COS connection
Values are: Enabled and Disabled.
Number of bytes of data that gets transferred from
the device to the linking device over the COS
connection.
Number of bytes of data that gets transferred from
linking device to the device over the COS
connection.
Section 4 Configuration
Table 21.
9ARD000014-600 A