ABB AC 800M Configuration page 155

Section 4 Configuration
Channel Name
CtrlSig In 1 Bit 00
Bit 01
Bit 02
Bit 03
Bit 04
Bit 05
Bit 06
Bit 07
Bit 09 (11) This bit, when set (1), indicates that counter 1 has been calibrated.
Bit 11 (13) This bit, when set (1), indicates a counter value is saved in store 1.
Bit 13 (15) Preset Reached - When this bit is set (1), in all configuration
Bit 15 (17) Count Direction - Increase/Decrease counter value of counter 1 set
Latch In 0 Bits 00-15 Saved counter value on channel 0
Latch In 1 Bits 00-15 Saved counter value on channel 1
Value In 0 Bits 00-15 Current value in counter 0
9ARD000014-600 A
Table 27. Description of Channels for 200-IP2 (Continued)
Bit
0 - Not Used
0 - Not Used
0 - Not Used
0 - Not Used
Status for input A (pulse transmitter 1) - This bit, when set,
indicates a signal at A
Status for input B (pulse transmitter 1) - This bit, when set,
indicates a signal at B
Status for input Z (pulse transmitter 1) - This bit, when set,
indicates a signal at Z
Status for input G (pulse transmitter 1) - This bit, when set,
indicates a signal at G
This bit is reset by CalReset.
This bit is reset by StoreReset.
modes, the counter 1 value equals the preset 1 value, either in a
positive or negative direction. This bit is reset by PresetReset1 and
can only be set again after at least 1 more pulse.
to 0 at startup.
0 = last pulse decreased counter value;
1 = last pulse increased counter value.
Configuring S200 I/O Modules
Definition
155