Table of Contents
Advertisement
Overview of Slots - Assembly Groups
Overview of Slots
Slot1
X1
X100
Schematic Diagram
In line with the customers' requirement, the devices are combined in a
modular way (in compliance with the order code). In each of the slots, an
assembly/group may be integrated. In the following diagram, the terminal
assignment of the individual assembly/groups are shown. The exact
installation/placement of the individual modules can be determined from
the connection diagram attached to the top of your device.
Slot2
X2
X101
X102
The housing must be carefully grounded. Connect a ground cable (AWG
2
12-10 [4 to 6 mm
] / 15 In-lb [1.7 Nm]) to the housing, using the screw that is
marked with the ground symbol (at the rear side of the device).
The power supply card needs a separate ground connection (AWG 14
2
[2.5 mm
] / 5-7 In-lb [0.56-0.79 Nm]) at terminal X1.
EMR-4000
Housing B2
Slot3
Slot4
X3
X4
X103
www.eaton.com
Slot5
Slot6
X5
X6
X104
IM02602009E
28
Advertisement
Table of Contents
