Eaton EMR-4000 Installation, Operation And Maintenance Manual page 245

Direct Commands of the Modbus
Parameter Description
Res Diagn Cr All Modbus Diagnosis Counters will be reset.
Global Protection Parameters of the Modbus
Parameter Description
Slave ID Device address (Slave ID) within the bus system. Each
device address has to be unique within a bus system.
Unit ID The Unit Identifier is used for routing. This parameter is
to be set, if a Modbus RTU and a Modbus TCP network
should be coupled.
TCP Port Config TCP Port Configuration. This parameter is to be set only
if the default Modubs TCP Port should not be used.
Port Port number
And Only available if: TCP Port Config = Private
t-timeout Within this time the answer has to be received by the
Communication system, otherwise the request will be
disregarded. In that case, the Communication system
detects a communication failure and the Communication
System has to send a new request.
Baud rate Baud rate
EMR-4000
®
®
www.eaton.com
Setting range Default
Inactive, Inactive
Active
Setting range Default
1 - 247 1
1 - 255 255
Default, Default
Private
502 - 65535 502
0.01 - 10.00s 1s
1200, 19200
2400,
4800,
9600,
19200,
38400
IM02602009E
Menu path
[Operation
/Reset
/Counter]
Menu path
[Device Para
/Modbus
/Communication]
[Device Para
/Modbus
/Communication]
[Device Para
/Modbus
/Communication]
[Device Para
/Modbus
/Communication]
[Device Para
/Modbus
/Communication]
[Device Para
/Modbus
/Communication]
245