Eaton EMR-4000 Installation, Operation And Maintenance Manual page 828

Signals of the Failure Simulator (States of the Outputs)
Signal
Running
State
Direct Commands of the Failure Simulator
Parameter Description
Start Simulation Start Fault Simulation (Using the test parameters)
Stop Simulation Stop Fault Simulation (Using the test parameters)
Failure Simulator Values
Value Description
State Wave generation states: 0=Off, 1=PreFault,
2=Fault, 3=PostFault, 4=InitReset
EMR-4000
Description
Signal: Measuring value simulation is running
Signal: Wave generation states: 0=Off, 1=PreFault, 2=Fault, 3=PostFault, 4=InitReset
www.eaton.com
Setting range
Inactive,
Active
Inactive,
Active
Default Size
Off Off,
PreFault,
FaultSimulation,
PostFault,
Init Res
IM02602009E
Default Menu path
Inactive [Service
/Test Mode (Prot
inhibit)
/WARNING! Cont?
/Sgen
/Process]
Inactive [Service
/Test Mode (Prot
inhibit)
/WARNING! Cont?
/Sgen
/Process]
Menu path
[Service
/Test Mode (Prot inhibit)
/WARNING! Cont?
/Sgen
/State]
828