SDMO R33C3 User And Maintenance Manual page 208

LEROY-SOMER
4.5.1 - Checking the winding
You can check the winding insulation by performing a high
voltage test. In this case, you must disconnect all AVR wires.
WARNING
Damage caused to the AVR in such conditions is not
covered by our warranty.
4.5.2 - Checking the diode bridge
A n o d e
A diode in good working order must allow the current
to flow from the anode to the cathode.
ou
+ -
~ ~ ~
- -
C C C
A A A
4.5.3 - Checking the windings and rotating
diodes using separate excitation
During this procedure, make sure that the alternator
is disconnected from any external load and inspect
the terminal box to check that the connections are
fully tightened.
1) Stop the unit, disconnect and isolate the AVR wires.
2) There are two ways of creating an assembly with separate
excitation.
12
InstallatIon and maIntenance
LSA 42.2 - 2 & 4 POLE
ALTERNATORS
A C
C a t h o d e
~
~
~
~ ~ ~
+ +
A A A
C C C
ASSEMBLY A
Exciter field
6 –
1A diode
+
-
12 V battery
Assembly A : Connect a 12 V battery in series with a rheostat
of approximately 50 ohms - 300 W and a diode on both field
wires (5+) and (6-).
ASSEMBLY A
-
Assembly B : Connect a "Variac" variable power supply and a
diode bridge on both exciter field wires (5+) and (6-).
Both these systems should have characteristics which are
compatible with the alternator field excitation power (see the
nameplate).
3) Run the unit at its rated speed.
4) Gradually increase the exciter field current by adjusting the
rheostat or the variac and measure the output voltages on L1-
L2 - L3, checking the excitation voltage and current at no load
(see the alternator nameplate or ask for the factory test
report).
When the output voltage is at its rated value and balanced
within 1 % for the rated excitation level, the alternator is in good
working order. The fault therefore comes from the AVR or its
associated wiring (ie. sensing, auxiliary windings).
Variac
AC
220 V
5 +
Rh. 50 Ω - 300 W
206/242
3433 en - 2010.10 / g
Exciter field
6 – 5 +
Rh. 50 Ω - 300 W
1A diode
+
12 V battery
ASSEMBLY B
Exciter field
6 –
+
1A diode
DC
-
12 V
5 +