Inlet And Exhaust Systems; Air Cleaner - Check; Turbocharger - Inspect - SDMO R33C3 User And Maintenance Manual

Chapter 8 PERIODIC INSPECTION AND MAINTENANCE PROCEDURES

Inlet and exhaust systems

Air cleaner - Check

Checking procedure described below is a commonly
used procedure. Some application may be equipped
with different air cleaner.
1. Check the air cleaner indicator for the element
clog.
2. If the element is clogged, the red signal mark is vis-
ible.
3. Immediately clean or replace the air cleaner ele-
ment when the signal turns red.
Note: For cleaning of the air cleaner element, refer to
"Air cleaner element - Clean, Check and Re-
place" (8-16).

Turbocharger - Inspect

Check the turbocharger when the engine is cold.
Also, make sure that the compressor wheel is not
rotating before inspecting the turbocharger.
If the color of the exhaust gas is abnormal, also
inspect the turbocharger.
Disconnect the pipe from the air inlet side. Hold the
compressor wheel nut by hand and turn the wheel to
check for looseness or abnormal noise. Replace the
turbocharger if looseness or abnormal noise is found.
Note: When removing and inspecting turbocharger,
contact a dealer of Mitsubishi Heavy Industries,
Ltd.
8-14
Reset button
Signal
(red)
Fig. 8-23 Air cleaner - Check
Turbocharger
Compressor wheel
Fig. 8-24 Turbocharger - Inspect
169/242