Introduction To Pictograms; Figure 17 : Description Of The Leds; Figure 18 : View Of Pictograms - SDMO R33C3 User And Maintenance Manual

A lit LED indicates:
Module being supplied (green, lights up and remains lit)
Emergency stop activated (control panel or external emergency stop) (red, lights up and remains lit)
Visualisation of starting phase and speed/voltage stabilisation (flashing) and generating set operating OK or set ready to
generate (green, lights up and remains lit)
General alarm (orange, flashing)
General fault (red, flashing).

Introduction to pictograms

6.2.1.1.
The pictograms are as follows:
Overspeed
Non-starting fault
Starting on external command
Preheating
Air intake
The "fuel level" pictogram is used to display the fault, the alarm and the fuel level.
The "operating temperature" and "oil pressure" pictograms are used to display the fault and analog value
The "overspeed" and "non-starting fault" pictograms are used to display the fault.
The "battery" pictogram is used to display the "alternator charge" fault and to indicate the battery voltage.
1 2

Figure 17 : Description of the LEDs

Operating temperature
Fuel
Oil pressure

Figure 18 : View of pictograms

54/242
3 4 5
Symbols for electric and
mechanical sizes
Battery
Delay