Horn Reset; Maintenance Schedule; Reminder Of Use; Maintenance Safety Instructions - SDMO R33C3 User And Maintenance Manual

In the event of a fault, the screen will display the following message:
FAULT
ALARM
ENGINE GENERAL 110 18
25/12/2005
OK=HELP
For JOHN DEERE (JD) and VOLVO (VO) engines, the codes displayed are SPN and FMI codes.

Horn reset

6.3.4.5.
Depending on the settings made (menu 363 - HORN), the activation of an alarm and/or a fault leads to the horn
sounding and the following screen appearing:
HORN STOP
PRESS OK
25/12/2005

7. Maintenance schedule

7.1. Reminder of use

The maintenance interval frequency and the operations to be carried out are outlined in the maintenance schedule, given as a guideline.
N.B. the environment in which the generating set is operating determines this schedule.
If the generating set is used in extreme conditions, shorter intervals between maintenance procedures should be observed
These maintenance intervals only apply to generating sets running on fuel, oil and coolant which conform to the specifications given in
this manual.

7.2. Maintenance safety instructions

Before each operation, please observe the following maintenance safety instructions:
read the safety instructions carefully (chapter 1),
refer systematically to the maintenance instructions,
the battery isolating switch must be in the open position,
no operations must be carried out while the motor is running,
wear protective equipment (gloves, goggles, safety shoes etc.),
before operating on a pressurised circuit, ensure that the circuit pressure has been reduced (atmospheric pressure),
after the operations, ensure that the equipment is clean, or clean it if necessary.
Engine fault code.
Pressing OK will display fault finding information.
In addition, appendix D indicate the meaning of the
code. The checking and maintenance operations to
15:30
carry out in order to solve the fault are included in the
user and maintenance manuals of the engines
supplied with the generating set documentation.
This screen will display first any messages relating to
the alarms and faults that appear as soon as OK is
pressed.
15:30
81/242