Siemens sinumerik 802d sl Operation And Programming Manual page 92

System
Time base
Fig. 7-18
Use this menu to parameterize the measuring channel.
Select
signal
Fig. 7-19
S Selecting the axis: To select the axis, use the "Axis" toggle field.
S Signal type:
Following error
S Status:
The parameters for the measuring time and for the trigger type for channel 1 can be set in
the lower screen half. The remaining channels will accept this setting.
S Determining the measuring time: The measuring time in ms is entered directly in the
"Measuring time" input field. It applies to all trace channels.
7-92
Time of marker position
Meaning of the fields
System deviation
Contour deviation
Actual position value
Speed actual value
Speed setpoint
Compensation value
Set of parameters
Controller input position setpoint
Controller input speed setpoint
Controller input acceleration setpoint
Speed forward control value
Exact stop fine signal
Exact stop coarse signal
On The recording is performed in this channel.
Off The channel is inactive.
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
Time difference between
marker 1 and current
marker position
6FC5 398-3CP10-0BA0