Siemens sinumerik 802d sl Operation And Programming Manual page 42

Setup
3.4 Programming the setting data
Softkeys
The working area limitation is active with geometry and additional axes. Enter the values for
Set
active
the work area limitation. Selecting the <Set active> softkey enables / disables the values for
the axis highlighted by the cursor.
Fig. 3-9
Timers Counters
Times
Counters
Fig. 3-10
Explanation:
S Total parts: Number of workpieces produced in total (total actual value)
S Parts requested: Number of workpieces required (number of workpieces setpoint)
S Number of parts: This counter registers the number of all workpieces produced since the
starting time.
S Total runtime: Total execution time of NC programs in the Automatic mode ( in seconds ):
In the AUTOMATIC mode, the execution times of all programs are summed between NC
start and program end / reset. The timer is zeroed with each power-up of the control sy-
stem. Time of execution of the selected NC program (in seconds)
3-42
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0