Siemens sinumerik 802d sl Operation And Programming Manual page 35

Table 3-1
Type
Dimension 1
Dimension 2
Sheet thickness
If the technology setup has not been read in by the toolbox or the wrong technology setup
has been read in, it might be that the supplementary tool parameters for the Nibbling con-
figuration are not yet activated. This is displayed to the operator.
Fig. 3-2
To open the complete parameter list, use <Advanced>.
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
Parameters of the tool list, continued
Field
Describes the type of the tool geometry:
1
2
3
4
5
6
7
8
9
99
104
105
106
108
109
110
111
112
Radius or length of the cutting edge
Width of the cutting edge
Maximum sheet thickness which can be machined
Message in case of a configuration error
3.1
Description
Round tool
Rectangular tool
Triangular tool
Double "D"
Single "D"
Long "D"
Elongated hole
Hexagon tool
Octagon tool
Free geometry
Multi-tool, 4 punches
Multi-tool, 5 punches
Multi-tool, 6 punches
Multi-tool, 8 punches
Multi-tool, 9 punches
Multi-tool, 10 punches
Multi-tool, 11 punches
Multi-tool, 12 punches
Setup
Punching and nibbling tools
3-35