Siemens sinumerik 802d sl Operation And Programming Manual page 36

Setup
3.1 Punching and nibbling tools
Fig. 3-3
Caution
The specified parameter list uses the parameters for the tool compensation. Therefore, the
G41 and G42 commands must not be used in the NC program.
Table 3-2
Parameters
DP4
DP5
DP6
DP7
DP8
DP9
DP10
DP11
DP12
DP13
DP14
DP16
DP17
DP18
DP19
DP20
DP21
DP22
DP23
DP24
3-36
Parameter list for a tool (Advanced)
Parameter list for nibbling
Field
Length 2
Length 3
Tool geometry
First multi-tool number
Y – Length of the cutting
edge
X – Length of the cutting
edge
Bottom dead center
Top dead center
Mounting bracket
Wear length 2
Wear length 3
DP16
DP17
DP18
DP19
DP20
Stroke counter
Base length 2
Base length 3
Envelope diameter
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
Description
Geometry of the Y axis
Geometry of the X axis
Describes the type of the tool geometry
First tool number of the punch on a multi-tool
Length of the A axis cutting edge
Length of the X axis cutting edge
Bottom dead center of the tool
Top dead center of the tool
Angle at which the tool is mounted
Y axis wear (fine compensation)
X axis wear (fine compensation)
Free
Free
Free
Free
Free
Stroke counter
Base length 2 (adapter), Y axis
Base length 3 (adapter), X axis
Diameter of the tool in the toolholder
6FC5 398-3CP10-0BA0