Siemens sinumerik 802d sl Operation And Programming Manual page 57

If "Program test" (PRT) is selected, the output of setpoints to axes and spindles is disabled.
Program
test The set point display "simulates" the traversing movements.
If you select this softkey, all traversing movements are performed with the feedrate setpoint
Dry run
feedrate
specified via the "Dry run feed" setting data. Instead of the programmed motion commands,
the dry run feedrate will be effective.
If this function is active, the program execution is stopped at the blocks in which the miscel-
Conditional
laneous function M01 is programmed.
stop
Program blocks marked with a slash in front of the block number are skipped during the pro-
Skipping
gram execution (e.g. "/N100").
If this function is enabled, the part program blocks are executed separately as follows: Each
Single
block fine block is decoded separately and execution is interrupted after every block. "Single Block
fine" can only be selected in the RESET status.
The feedrate override switch also acts on the rapid traverse override.
RTO
effective
Use this softkey to quit the screenform.
Previous<<
Use the block search function to go to the desired place in the program.
Block
search
Forward block search with calculation to the block end point
To
contour
During the block search, the same calculations are carried out as during normal program
operation, but the axes do not move.
Forward block search with calculation to the block end point
To
end point
During the block search, the same calculations are carried out as during normal program
operation, but the axes do not move.
Block search without calculation
Without
calcul.
During the block search, no calculation is carried out.
The cursor is positioned on the interruption point.
Interr.
The "Find" softkey provides the functions "Find line", "Find text" etc.
Find
Use this softkey to correct a faulty program passage. Any changes are stored immediately.
Program
correction
Opens the G functions window to display all G functions currently active.
G
function
The G functions window displays all G functions currently active whereby each G function is
assigned to a group and has a fixed position in the window.
Use the <PageUp> or <PageDown> keys to display further G functions.
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
AUTOMATIC Mode
5-57