Siemens sinumerik 802d sl Operation And Programming Manual page 2

Safety information
This manual contains information that must be observed to ensure your personal safety and to prevent
property damage. Notices referring to your personal safety are highlighted in the manual by a safety alert
symbol; notices referring to property damage only have no safety alert symbol, and, depending on the
degree of hazard, represented as shown below:
Danger
!
indicates that death or serious injury will result if proper precautions are not taken.
Warning
!
indicates that death or serious injury may result if proper precautions are not taken.
Caution
!
with a warning triangle indicates that minor personal injury can result if proper precautions are not taken.
Caution
without a safety alert symbol, indicates that property damage can result if proper precautions are not taken.
Notice
indicates that an undesirable event or state may arise if the relevant note is not observed.
If several hazards of different degrees occur, the hazard with the highest degree must always be given
priority. A warning notice accompanied by a safety alert symbol indicating a risk of bodily injury can also
indicate a risk of property damage.
Qualified personnel
The associated device/system must only be set up and operated using this documentation. Only qualified
personnel should be allowed to commission and operate the device/system. Qualified persons are defined
as persons who are authorized to commission, to ground, and to tag circuits, equipment, and systems in
accordance with established safety practices and standards.
Proper use
Please note the following:
Warning
!
The equipment must only be used for single purpose applications explicitly described in the catalog and in
the technical description and it must only be used along with third-party devices and components approved
by Siemens. This product can only function correctly and safely if it is transported, stored, set up, and
installed correctly, and operated and maintained as recommended.
Registered trademarks
All designations with the trademark symbol ® are registered trademarks of Siemens AG. Other designations
in this documentation may be trademarks whose use by third parties for their own purposes may infringe the
rights of the owner.
Disclaimer of liability
We have checked the contents of the documentation for consistency with the hardware and software
described. Nonetheless, differences might exist and therefore we cannot guarantee that they are completely
identical. The information given in this publication is reviewed at regular intervals and any corrections that
might be necessary are made in the subsequent editions.
Siemens AG
Automation and Drives
Postfach 4848
90437 NÜRNBERG
GERMANY
Copyright (E) Siemens AG 2005.
6FC5398-3CP10-0BA0
Siemens AG, 2006.
Subject to change without prior notice.