Workpiece Clamping – Settable Work Offset G54 To G59, G500, G53, G153 - Siemens sinumerik 802d sl Operation And Programming Manual

Programming
8.2 Positional data
Programming example
Mirroring in different coordinate axes with influence to an enabled tool radius compensation and G2/G3:
...
N10 G17
N20 L10
N30 MIRROR X0
N40 L10
N50 MIRROR Y0
N60 L10
N70 AMIRROR X0
N80 L10
N90 MIRROR
...
Subroutine call – see Section 8.9 "Subroutine technique "
8.2.9 Workpiece clamping – settable work offset:
G54 to G59, G500, G53, G153
Functionality
The settable work offset specifies the position of the workpiece zero on the machine (offset
of the workpiece zero with respect to the machine zero). This offset is determined upon
clamping of the workpiece into the machine and must be entered in the corresponding data
field by the operator. The value is activated by the program by selection from six possible
groupings: G54 to G59.
Note: Workpiece clamping at an angle is possible by entering the angles of rotation around
the machine axes. These rotation portions are activated with the offset G54 to G59.
For information on operation, see Section "Setting/changing the work offset"
Programming
G54
G55
G56
G57
G58
G59
G500
G53
G153
8-146
; X/Y plane,
; Programmed contour
; The direction is changed in X
; Mirrored contour
; The direction is changed in Y
; Mirroring once more, but now in X
; Contour mirrored twice
; Mirroring OFF.
; 1st settable work offset
; 2nd settable work offset
; 3rd settable work offset
; 4th settable work offset
; 5th settable work offset
; 6th settable work offset
; Settable work offset OFF – modal
; Settable work offset OFF – non–modal,
; Suppresses also the programmable offset
; The same as G53, but suppresses additionally base frame
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0